Introduction
SAP B2B Add-on comes up with standard X12 message content for various message types .The standard message content(for e.g: 945 message of 004010) will not suit for all the customer needs. There could be cases, where the converted XML payload deviates from the expected output xml.
In this blog, I would be explaining the step-by-step procedure required for creating and configuring the customized ANSI X12 messages.
Pre-requisites
Step 1:
As mentioned in the note #2205708 ,Change the property value of the "x12.loop.allowduplicates" to true
Step 2 :
Select the version, transaction set and click on Copy Control Key button
Step 3:
You need to edit the newly copied control key as per your needs.
In this particular example, i would be adding a new segment (W12) after N9 segment inside the loop L_300.
Step 4:
You can test this message using Convert Ansi.X12 to XML tool. Make sure you select the new Control Key while converting the payload as shown below.
Step 5:
Add a new entry in the Control Key Scenario Association Table .
Note : At least one value should be different than .* for the newly added scenario association entry. Otherwise,it will cause failures for the existing scenarios.
Step 6:
In case if you are using TPM Agreements for the conversion,
With these steps, You should be able to create and run scenarios for customized payloads.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
13 | |
10 | |
10 | |
9 | |
8 | |
7 | |
6 | |
5 | |
5 | |
5 |