Table of Contents

Step 1: Verifying the configuration parameters for ICM

Step 2: Activate Required Services

Step 3: Publishing Services

STEP 4: Login In to the SAP GUI though Web.

Summary

The purpose is this document is to show step by step to configure webgui for SAP Netweaver . Applies to SAP Netweaver R/3 System

Author:      Priyashantha Fernando

Company: CPSTL – Sri Lanka

Step 1: Verifying the configuration parameters for ICM.

Use Transaction SMICM (ICM Monitor).
Displays the ICM configuration and monitoring. Make sure it is running. Check the following ICM parameters.

[Menu-> Goto -> Parameters ->Display]

1. icm/server_port_0 PROT=HTTP,PORT=8000
2. icm/host_name_full <Full Qualified Domain Name>

I will use the domain name as testp1.bomain.cpstl

Following parameters should be checked.

Step 2: Activate Required Services:

Following 3 services need to be enabled.

1. /default_host/sap/bc/gui/sap/its/webgui
2. /default_host/sap/public/bc/ur
3. /default_host/sap/public/bc/its/mimes

Use Tcode ‘SICF’ to enable services. Then execute it to show the services trees.

Then activate the mentioned services according to the below guide.

1. /default_host/sap/bc/gui/sap/its/webgui
2. /default_host/sap/public/bc/ur
3. /default_host/sap/public/bc/its/mimes

Right click on the relevant service and then activate it.

Step 3: Publishing Services:

Run T-Code SIAC_PUBLISH_ALL_INTERNAL  to activate the services. Will take few minutes. While running it will show the status message like:

Finally the following screen can be seen.

STEP 4: Login In to the SAP GUI though Web

Type one of the following URLin the web browser

1. http://<IP>:8000/sap/bc/gui/sap/its/webgui
2. http://testp1.bomain.cpstl:8000/sap/bc/gui/sap/its/webgui

Then the login screen will come.

Then ask you to provide the username and password. Login an roam in to the SAP 

Refecence : SAPNOTE 517484