Post processing steps for SAP BW system copy or db copy

[Former Member]

Post processing steps for SAP BW system copy.

After system copy, you nees to perform some post action to reactivate the extractors

Usually, to have the data sorted, you refresh both the source and target system.

If you run the refresh only the BW system, you can ignore the first paragraph

Action in souce system

• BDLS

Converts occurrences of the value for logical system name in various tables.

Convert BAPCLNT100 in BATCLNT100

Convert <LOGICALNAMESOURCE_PROD>in <LOGICALNAMESOURCE_TEST>

Do not continue until both the logical names have not been converted

• scc4

check if in Logical system  name is correct ( BDLS should fix it )

• sm59

check that it exists and functions, the RFC connection BATCLNT100

• we21

check that there is a door that points to BATCLNT100 (ex change the port A0000000XX that points to the system of production BW)

• sale

create new logical system BATCLNT100 (note the system must be open to change in order to change the table)

• we20

create new logical system BATCLNT100 like LS type, you must reset all flags of BAPCLNT100. So the most 'safe is to create it as a copy of BAPCLNT100 (the "No Partner" is the logical system, not the RFC connection!). After that in Outbound parmtrs, click twice on the message t ype, the screen will open with the parameters configured, check that the door is the same as previously configured in WE21.

Check that in Classification , patner status is active ( A - active , I - inactive).

Action in bw system

• BDLS

converts occurrences of the value for logical system name in various tables.

Convert BAPCLNT100 in BATCLNT100

Convert <LOGICALNAMESOURCE_PROD>in <LOGICALNAMESOURCE_TEST>

Do not continue until both the logical names have not been converted

• SE16

Check the entry in follow table; should relate to the test

RSLOGSYSDEST

RSBASIDOC

• se37

Function: RSAP_BIW_DISCONNECT

Parameter   I_BIW_LOGSYS                  <<SLOGSYS>>

                      I_OLTP_LOGSYS                <<RLOGSYS>>

                      I_FORCE_DELETE              X

• we21

check that there is a door that points to BATCLNT100 (ex change the port A0000000XX that points to the system of production BW)

• sale

create new logical system BATCLNT100 (note the system must be open to change in order to change the table)

• we20

create new logical system BATCLNT100 like LS type, you must reset all flags of BAPCLNT100. So the most 'safe is to create it as a copy of BAPCLNT100 (the "No Partner" is the logical system, not the RFC connection!). After that in Outbound parmtrs, click twice on the message t ype, the screen will open with the parameters configured, check that the door is the same as previously configured in WE21.

Check that in Classification , patner status is active ( A - active , I - inactive).

• rsa1

   

     right --> restore

     User administrator

    continue

     Use

also replicate

Dialog

execute evaluation

references

http://help.sap.com/saphelp_NW70EHP1/helpdata/en/13/035038bbc3be03e10000009b38f8cf/content.htm

http://help.sap.com/saphelp_NW70EHP1/helpdata/en/13/035038bbc3be03e10000009b38f8cf/content.htm