Enterprise Resource Planning Blogs by Members
Gain new perspectives and knowledge about enterprise resource planning in blog posts from community members. Share your own comments and ERP insights today!
cancel
Showing results for 
Search instead for 
Did you mean: 
jogeswararao_kavala
Active Contributor

Objective:

To automatically populate the list of Tasks upon selecting 'Priority' in a Notification.

Different sets of Tasks will be populated automatically according to the selected 'Priority' value.

Introduction:

Because this process is based on a 'Priority type' which is assigned to a notification, often custom notification types are preferred for this process.

(This is where the standard notifications prefer other priority types.)

Here the custom notification type is 'AC' and a case of Overhauling process of HVAC equipments is demonstrated.

The End result of this document is illustrated here:

Create a notification, select the priority ( Say here 'PAC O/H' ) , then in the menu bar go for

Edit --> Tasks  --> Determine .

Set of tasks relevant to 'PAC O/H' are populated automatically, as shown in the images1,2,3  below.

Image1 (IW21/IW22)

Image2

Image3

Now let's see what is to be done to achieve this:

1.SPRO: Define Priority

In above picture, Rel.end field specifies the number of days the job takes to complete.

(Determines the Required Start and Required end dates of the Notification upon selecting the prioirty)

Note the Priority numbers in the above picture (1,2,3,4,5 etc), which will be referred in the forthcoming steps

2. QS41: Create Task CodeGroup (ACOH)& Codes

(List of all jobs related to all types of HVAC equipments)

3.SPRO: Define Response Monitoring

Create Response Profile '00000005'

Specify the Catalog type (2), Code Groups and Codes as under against priority values 1,2,3 etc (Referred above)

(So many number of priority values as many the equipment types)


Define Service Profile.

Specify Service profile and Response Profile against Notification type.

Now your Notification Type 'AC' is enabled to determine tasks automatically, different set of tasks with different value of 'Priority type' as demonstrated in the beginning of this document.

Application in maintenance plans using Notifications:

See the picture below. When these settings are made during the plan creation, the triggered notifications come alongwith the set of Tasks.


Thank you

-Jogeswara Rao K


35 Comments
Labels in this area