Hi QM Gurus,
I'm creating Inspection lots back of PM Orders for preventive maintenance. The Inspection lot carries Quantitive Inspection Characteristics. Also I maintain the upper and lower level specification (e.g. upper limit 10, lower limit 5)
When I do the result recording in QE51N, depending on the result I enter system determines Accept or Reject. E.g. if I enter 7, system gives a pop-up automatially selecting Accept; if I enter 3 it selects Reject.
But the issue I have is, I still can change what system proposes either to Accept or Reject. Is there a way to stop this? Simply I dont want system to show the Accept/Reject pop-up. The value entered is the only input expected from the user.
Your help is highly appreciated.
Apart from this ensure you are not using sampling procedure that contains manual valuation.
Perhaps you may need to set appropriate selected set under proposal for inspection point valuation on the same screen, in case you are dealing with inspection points.
Hi Sujit & Anand,
I am also facing same problem, I do not see Automatic valuation mode in sampling procedure.Also i have tried Mr. Anand suggestion, Maintain plant setting --> recording Config.---> All background function but still i am getting that Accept/ Reject pop-up.
There can be one possiblity that system is not able to decide whether char is accepte or rejected ...say you have selected valaution mode in SP as " attributive inspection according to nonconforming units " and system not able to determine nonconforming sample units from result you enter and so on.
I tried with following steps and it worked fine for me.
After this, you need not click on lock symbol in QA32, system does it automatically and valuates also as per the acceptance number. Kindly confirm what acceptance number and valuation mode you are using.
Message was edited by: Anand Rao Last 2 lines edited
I tried as per your steps mentioned and working fine but my setting in IMG for result recording configuration is "no background function"
Presently I am not getting that Accept/Reject pop-up now but i found that when i valuate that inspection lot for off spec. value also it marks green i.e. Accept. Actually it should be red ( rejected) . Can u explain more on this or is it dependent on acceptance number ?
Initially, For sampling procedure my setting was "Fixed sample" and valuation mode was "SPC Inspection " In earlier reply sujit also suggested the same and he was also correct.
Thanks for clarification,
Yes. It depends upon acceptance number. I try to explain further.
Lets say I am using FIXED5 sampling procedure with 2 as acceptance number. It means that out of my 5 readings if 2 fall outside the tolerance range then also the valuation would be accepted. Kindly refer following screenshot.
Is this your scenario? Regards,