Thanks Amit . I did that i got the sequence number 58 to 75 under RWB- Adapter engine. I tried to resend 58 but status HOLDING remains the same. When I try to cancel it says Unable to Cancel 1 of 1 messages.
There are no messages in the queues. Also in PI 7.1 there is no column conversation ID.
Hi,
>>Also in PI 7.1 there is no column conversation ID
You can select and increase ur message search range.
Thanks
Amit Srivastava
If the messages are processed in EOIO mode and if the first message in the queue got blocked for some reason like data issue or huge volume processing then the following messages will be found in the hold state. You need to see what is the cause of the delay of the previous message processing? You did re - register the queue in SMQ2 right? The stefan blog above might help you to guide on using the filter option to search the messages in hold.
Hi,
If the messages were in holding status in Message monitoring-RWB-Adapter engine then cancel the messages in RWB it self.
What exactly the issue in your case after reprocessingt in SXMB_MONI messages were got struck in SMQ2?
Regards,
Raj
Hi Raja,
I selected all the HOLDING messages in RWB and selected CANCEL and i get message Unable to cancel -Predecessor not in final state. I checked there are no other HOLDING messages or error messages. In SXMB_MONI there is one error message due to Mapping exception.
Also i deleted all the error messages from the queue . I am not sure what else needs to be done.
Please advice.
Teresa,
You already posted very similar situation before and Mark answered for this.. You might want to check this thread..
Hi,
Step1:
Go to runtime work bech--->Message Monitoring---Adapter Engine.
Step2:
Check wts the status of your holding message by comparing first step.
If it is in Scheduled status then cancel it .
Step3:
If Step2 operation not successfull then stop the receiver channel and reprocess them , after some time message will go to system error status then you can cancel the messages and it will go in to terminated with error status.
Best Regards,
Raj
Is there a option to delete these messages at OS level . When there are 5000 messages stuck with HOLD status ?
is it production environment? I would not recommend to delete the messages. Plus I dont think it is possible to delete messages at OS level that are in HOLD state.
You have to run jobs to removed these entries, for time being cancell all messages so that wll messages will got terminated with error status.
Take help from Basis team to schedule archive and deletion job to remove all success//failed messages.
