cancel
Showing results for 
Search instead for 
Did you mean: 

No quants exist for posting changes. Creating TOu00B4s in LU04.

Former Member
0 Kudos

When creating transfer orders in LU04, we get an error message "No quants exist for posting changes'. We are using batch managed and serialized materials. Using QM interface, so, inspection lots are created at Goods Receipt. When QM team "accepts" batch materials during inspection lot, there is no problem, but when "accepts" serialized materials, the system creates posting changes notices but can not create transfer orders sending the message before described. This is because after receiving the serialized materials, we receive one piece at a time in order to create one inspection lot for every serial number. But when we put away the materials, we put them away in the same bin. so, system assigns one quant and one inspection lot to the bin, updating the last one every time we put away one serial number. When system tries to look for the inspection lot number selected in QA32, is not finding it in the bin at WM level because the bin only contains the last inspection lot that was put it away.

With batch managed numbers there is no problem since SAP divides the bin in different quants with the correspondent batches assigning an inspection lot to each quant.

Is there any alternative to solve the issue with the serialized materials? We are using SAP ECC 6.0.

Thanks for any help.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi,

Why you put away the serialized materials into the same bin? If you can put them away into the separate storage bin, I think you can solve the problem.

Good luck

Tao

Former Member
0 Kudos

Hi,

The reason why we put away serialized materials into the same bin is because materials are physically small and they fit more than one in each bin. The warehouse is structured in this way and we plan to use it like that because it wouldn´t be feasible to create one bin for each serialized material. Is there any other way to manage this situation?

Thanks in advance.

Answers (1)

Answers (1)

former_member536836
Active Contributor

Hi,

I believe your issue lies in quant merging ,please refer following SAP note & act on it.

Note 389492 - Warehouse Management(WM)/Quality Management(QM) interface

Hope this will clear issue.

Regards,

Prashant

Former Member
0 Kudos

Thanks Prashant, note Note 389492 worked just fine.

former_member536836
Active Contributor
0 Kudos

Welcome.

It's good that your problem solved with this note.

Regards,

Prashant