on 03-15-2006 3:39 PM
Hi all,
I am using infosource 0MATERIAL_ATTR (flexible update) to load master data into infoobject 0MATERIAL using update rules.
<b>My question is: If I use this infosource (0MATERIAL_ATTR) and update rules to load master data into infoobject 0MATERIAL can I use the same infosource (0MATERIAL_ATTR)but different update rules to load data into another infoobject (e.g a copy of 0MATERIAL).</b>
Thanks
Christian
yes you can do that.
one infosource can be used to feed multiple datatargets / infobjects..
Regards,
BWer
if helpful assign points.
Message was edited by: BWer
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Christian
You can upload to other infoobject also as long as it is marked as Infoprovider.
Thnaks
sat
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Christian, Yes. i think you can use it for copied infoobject of 0material.
regs,
Vachan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Christian,
That would be possible (one of the adv of flexible updates). Just check whether your other InfoObject has been set as a data target/ InfoProvider (RSD1 > Mater data/text tab).
Hope this helps...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.