on 05-06-2009 4:47 AM
When i execute the DTP to load from DSO to a cube, it executes and gives the message 'No more data available'. The request is green but no data is transferred from the DSO. Request in DSO is active and I tired both delata and full load. Any idea?
Thanks
Hello,
I am also getting this kind of error. When I execute DTP (DSO -> CUBE) request turns into green but no data transfers.
Regards,
Amit Patil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Amit
There might lot of reasons for this issue. We could check one by one
1. Check if your DSO request is activated and there are records added
2. Check if you have filters set up in the DTP from DSO to Cube
3. Check if you have any start routine to delete certain data. For instance, Delete source if material type is 'blank'. If the data in DSO has blank material type, it will get deleted there
Please share these details. The we could get in further
Has this Issue been resolved ?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Do load data directly from DSO to Cube or do you use the PSA?
If you do not use the PSA a full upload should contain data. But do not forget that the data in the DSO has to be active. DTP in standard only loads data which has been activated.
Regards,
Percy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
69 | |
26 | |
9 | |
9 | |
7 | |
6 | |
4 | |
4 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.