Error: "The entry 1111 is missing in table T043S"

[Former Member]

Hello All,

While clearing a G\L account the below error was encountered:

"The entry 1111 is missing in table T043S"

1111 is company code,

However when I look at the table T043S, 1111 is there.

Could help me to figure out what might be the other cause of this error?

Thanks in advance!

Jhero

[Former Member · Accepted solution]

Hello,

The account already maintained in OBA4 and OBA3

Thanks!

Jhero

[former_member182098 · Accepted solution]

For your company you SHOULD have TWO tolerance group, one with BLANK and one with NAME.

Please check up.

Regards,

Ravi

[Former Member]

Hi

We are facing same problem , I resolved this error

This error is tolerance for group of GL accounts in Local Currency

Go to T code OBA0

and maintain the tolerance for GL

Put ur company code only, leave the Tolerance fields Blank

Edited by: KANILKUMAR on Dec 20, 2011 5:20 AM

[former_member724432]

Hi Anil.

Hope you're doing good. I have maintained same as you mentioned . However still am facing the same issue. Please Asssit me in this. Thanks.

[Former Member]

Hi

This error is tolerance for group of GL accounts in Local Currency

Go to T code OBA0

and maintain the tolerance for GL

Put ur company code, leave the Tolerance fields Blank

It will resolve ur error

Thanks

SAPUSER5

[former_member809040]

Thank you sir..your solution helped me.

[Former Member]

Hi guy,

I solve this issue with maintain tolerance group of G/L account in local currency in tcode OBA0.

regards,

ng chong chuan

[Former Member]

Thanks, this worked for me too.

[prabhapotdar]

good .. OBA0 config helps

[Former Member]

Hello,

What is the reson for maintaining 1 with blank and 1 with name?

Thanks!

Jhero

[former_member182098]

Frankly I do not know the logic behind this.

But, we faced the similar problem and realized the reason is not maintained two tolerance groups. (blank and name)

Regards,

Ravi

[Former Member]

Even i mentained 2 tolerace as you said but not working

Regards,

[former_member182098]

Hello,

In T043S and T043G (OBA3) you need to create two tolerance limits.

one tolerance limit with some name

second tolerance limit without any name (blank)

If you do not create tolerance limit blank then your tolerance is not going to work.

First create tolerance group blank for your company code, then copy that tolerance and give some name for your company code.

Hope it should solve your issue.

Regards,

Ravi

[Former Member]

Hi,

Please maintain the FI tolerance for user in Tcode "OBA4" . just assign company code . please do not mention the group. only mention the c code.

Regards

Amit

[Former Member]

Hello,

Thanks for the feedback.

where do I have to check the tolerance?

in table T043S?

Thanks!

Jhero

[Former Member]

Hi,

Go to SE16N, enter the table T043S and push 'View maintenance'. Maintain the entries for your company code.

Regards,

Phaneendra

[Former Member]

Hi

and also u can check t.codes OBA4 and OBA3

Thanks & Regards

Phaneendra

[Former Member]

hi

Please check toleracne wheter u have maintained or not if not pls maintain

Thansk & Regards

Phaneendra