cancel
Showing results for 
Search instead for 
Did you mean: 

Sample not calculated

tanuj_parikh
Active Participant
0 Kudos

Dear Gurus,

Insp Lot is showing status REL CALC, though sample is not calculated. Why is it so? And hence RR screen is not showing any Chars.

When I reset thru QAC3, Insp Lot got the status, CRTD. Then I manually calculate the Sample, Sample got calculated and Insp Lot got the Status REL CALC again and I am able to record result. This means all Master Data are correct.

Why System has not calculated Sample automatically and set the status CALC?

Regards,

Tanuj Parikh

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi,

Are you using any sampling drawing procedure If you are using it then you need to go always in QA02 change inspection lot.where click on sample tab to calculate sample qty.

If you are not using sampling drawing procedure.

Then in sampling procedure QDV2 check sample size should be 1

Regards

SANIL

tanuj_parikh
Active Participant
0 Kudos

Hi,

Thanks for reply.

To elaborate, such Insp Lot is created thru Maintenance Order RELEASE having Insp Point: 300 with std settings.

General TL is having MIC with Sampling Procedure and Base Sample Qty = 1.

Sampling Procedure is with Sampling Type = Fixed Sample, Valuation Mode=Manual, Insp Pt: Plant Maintenance, Sample Size=1.

Regards,

Tanuj Parikh