Number range error

[Former Member]

Gurus,

I have created a group in MMNR & assigned matl type.When i try to save i am geting this error.

System error during group maintenance

Message no. NR899

Diagnosis

The system has identified an inconsistency in the tables for number range maintenance.

System Response

Program termination.

Procedure

In most cases, you can overcome this by executing the report RSSNR0T1 (Consistency check and repair of number range intervals). This report lists the inconsistencies and eliminates them (with F11 = "Confirm").

[BijayKumarBarik · Accepted solution]

Hi,

For existing group the number range was not maintained.First Create create a new group, assign the group to a number range interval & assign a material type to the group and save.

For more check the links:

http://www.scribd.com/doc/18180994/SAP-Material-Number-Ranges-and-Formating-20090806

Regards,

Biju K

[Former Member]

Check this link:

Note 11294 - Not possible to add number range groups

Summary

Symptom

Key word: Num range grps

When you add number range groups, the new intervals are saved, but not the group itself.

Additional key words

Cause and prerequisites

Inconsistency between the table of number range intervals (NRIV) and the (language-specific) table of number range groups (TNRGT). The inconsistency could have arisen due to a transport, for example, in which not all the logically cohesive objects were transported.

Solution

Report RSSNR0T1 returns a list of the inconsistencies. Press F11 = Confirm/Save on the results list and the report restores a consistent status.

Edited by: Afshad Irani on Jul 17, 2010 5:47 PM

[Former Member]

Hi,

Check this link also:

http://www.sap-img.com/mm003.htm

SAM

[Former Member]

HI,

Pls check the below mentioned thread.It will help you.

Pls check & revert if issues resolved,

Regards

Sanjay