on 08-26-2010 3:47 PM
Hi,
I want to create Cube compression process chain so that it will automate the process to compress the cube.
Could any please provide me the steps to create Process chain to automate the cube compression.
Regards,
Prem.
Please search the forum
Edited by: Pravender on Aug 27, 2010 11:54 AM
Hi,
You can modify ur process chain in RSPC.
Get into change mode in planning view and in the left side check for the different process where you can find the Compression process.
Drag the same to right section and create a variant for the same and give the cube name. Once done then you can put the same after the cube load process (If roll up is there then it shud be after rollup if not then cube load process).
Once all changes are done then, activate it and collect the same in transport to move the changes to next level.
Hope this helps.
Murali
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Are you also loading the cube with a process chain?
Cos you can just place a compress process and rollup process at the end of your chain
Hope this information helps
Best Regards
Barry
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
While creating a process chain in RSPC check for the process types on the left had side. Under Data Targets Administration you can find the Compression of the InfoCube
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.