MIC changes in routing/inspection plan

[Former Member]

Hi, we have created qualitative inspection characterisics (without characteristics attribute control indicator) with incomplete copy model type. This is already assigned in inspection plan and in routing. Now our users want to assign characteristics attribute. We changed the MIC control indicators. this is not reflecting in the routing/inspection plan.

Could anyone suggest the best way to update the inspection characteristics in inspection plan as well as in routing.

[milind_kulkarni5]

Hi,

Clear the stock with early settings & then try to maintain new setting in Quality Plan, MIC & routing accordingly.

Pls. revert.

Regards,

Milind

[Former Member]

Hi,SK :

      First ,you should know the complete  copy model :if you use it ,then the MIC in the  inspection plan don't be impacted anymore,even if modify the MIC .there is one way that you can use the reference characteristic.

[vasudevap_pushpalas]

Dear !!!!

Please Follow this steps

1.Check Inspection Setup What u have given

2.Create a Quality Work center with control Key QM01

3.Create Master Inspection Characteristic in QS21

4.Create Quality Plan QP01 make sure your usage type 5 0r 6

5.Assign inspection characteristics in master inspection whatever u have created in QS21 save

6.Go to QA32 check with selection by material or by plant

7.Then go to QE51n and run by selection condition by material or by plant Results recording starts

Then click on the Inspection lot make the inspection and save it will prompt saying that results save under operation

9.Then go to Usage decision QA32

10.Move Material From Quality To Unrestricted.

Thatu2019s all the Steps

With Regards

Pushpalas

[former_member42743]

When you use incomplete copy model mics, once they are copied into a plan, any future changes to the MIC must be addressed by editing, one-by-one, every plan/routing it is used in and either replacing it with a new version, or making the same identical change in directly in the plan.

It is why, I always try to use reference MIC's instead when possible. Some design may not be able to do that however.

FF

[Former Member]

Dear

MIC changes are not reflected in Inspection Plan or wherever these characteristics has been assigned, go to routing / task list and change indicator then changes will be reflected

[Former Member]

Hi,

Whenever you make changes in inspection characteristics, it automatically creates the version number.

Now go to the inspection plan/routing and delete the MIC and re-assign, it will ask to enter the version number.Enter the relevant version number so that it will get updated

Regards

Hari