on 01-04-2012 8:37 AM
Hi Friends,
While creating material in MM01, I'm getting an error as
Entry XXX XXX does not exist in T001L (check entry) Message no. 00058
Diagnosis
Input values must be defined in Table T001L. The value or values 'ZAN1 ZAN1 ' are not specified in this table
Procedure
Check whether the input is correct and correct if necessary.
Procedure for System Administration
If this is not an incorrect entry, check the system settings and change them if necessary.
If there is a connection to the Customizing system, you can maintain the system settings by choosing Customizing in the Performance Assistant or Maintain Entries (F5) when displaying the help in a modal dialog box.
I created the Sales Org, Distribution Channel, Division in SD and assigned them to one another. Still it's giving error and when I try to input Division & Distribution channel in initial screen of MM01 they're (my own Division & Distribution channel) not getting displayed in drop down list.
Can anyone please help me in this issue.
Thanks,
Pavan
You would not have assigned the storage location to plant which you can check in ox09
G. Lakshmipathi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
SPRO-> Materials Management->General Settings for MM->Requirement Prioritization->Assign Plants & Storage Locations
Follow this path and maintain your plant and storage locations
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Friends,
The Issue is resolved by doing the below stated step.
Go to SPRO-> Materials Management->General Settings for MM->Requirement Prioritization->Assign Plants & Storage Locations
Here you assign your Plant, Storage Location to one another and Save.
Thanks,
Pavan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Pavan,
Please refer to the following thread. Hope it helps.
Regards,
Sridhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Maintain common dist channel and common division
SPRO>S&D>Master Data> Common Dist channel and Common Div
If you have not created new common Dist channel or division the maintain the same which you have defined.
and check storage location assignment
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.