PO release procedure

[ramesh_reddy25]

HI All

I have configured Release procedure for PO.

i have created 3 characteristics for doc type,PO value and Purchase group.

My requirement is, i have to give purchase group for only 2 release strategies for other release strategies only doc type and value details in classification.

I have not included any purchase group details in one release strategy.

In PO creation Release procedure is working for with purchase grp release strategies but release tab/release procedure is not working for with-out purchase group release strategy.

plz help me how to do.

thanks and regards

ramesh reddy

[Former Member · Accepted solution]

when you setup release criteria as pur. group, you need to provide the purchase groups in CL24N for all the release strategies to trigger the release in PO. moreover purchase group in mandatory in PO, so whats wrong in providing the purchase group data in CL24N and enter the same in PO.

Otherwise remove the purchase group from release at all and not for one release strategy.

[Former Member]

Hi,

check this link and configure

G.Ganesh Kumar

[Former Member]

Hi Ramesh,

As you have assigned purchase grp as a character in the release class, in strategy also you have to feed value for purchase group.You can't skip the purchase grp in any release strategy.

You can approach these two cases as below.

Case I

Purchase group for only 2 release strategies.

Answer:

You can create these two release strategies with the the specific purchase grp, PO doc type and PO value combinaton.

Case II

For other release strategies only doc type and value details in classification.

Answer:

Tihs means,release strategies depends only on specfic PO document type and PO value.

So it has to work irrespective of the purchase group you selected in the PO.

So,you setup these strategies in such a way that to add all the purchase grp(except the Purchase grps.you selected for case I) and with specific doc.typ and PO values combination.

Please try and reply me if you are ok with this solution.

reg,

Mariappan

[former_member193326]

Hi,

The only solution is to enter blank as characteristic value in the customizing or try to handle this situation with the user exit:

EXIT_SAPLEBND_002

Best Regards,

Arminda Jack