Position Description Change

In Table T77S0,

IS PLOGI     PRELU set to blank?

Is PLOGI SPLIT set to X?

Have you tried running RHINTE30 and checked if ti is updating then?

Regards

Please try to change the position description in the change mode without delimiting the record

Change the description then come out from the employee no. then go again to this employee no. it will reflect the new one.

OR

Check the Switch PLOGI SPLIT in V_T77s0

Regards

Sushilkumar

Edited by: sushil7666kumar on Feb 25, 2012 7:28 AM

Hi,

Try changing description in PP01 transaction and then running integration report and also verify if you are using correct position and date to make changes.

Also verify if PLOGI switches like ORGA is activated before integration reports are run.

Thanks,

Ameet

Hi,

I hope by maintaining the integration table T77S0, these can be managed:-

PLOGI SPLIT Integration: New IT 0001 record at name change

PLOGI PRELUIntegration:Integration: PA update online or batch, you can use RHINTE 30 .

PLOGI TEXTC Integration: transfer short text of job

PLOGI TEXTO Integration: transfer short text of org.unit

PLOGITEXTS     Integration: transfer short text of position

Hope this solves your issue.

Hi,

Go to PO13, select the position and click on change for change of description.

After which run relevant RHINTE reports.

Check the integrations.

This should solve your problem.

Venu