Hi Sandy,
If you are using SAP BI 7.x version then you will not have the option of using infopackage to load data between data targets. In SAP BI7.x version InfoPackage is used to load data from Source system till PSA only. You have to use DTP to load data into Data Targets.
Regards,
Shilpa
Hi Sandy,
On which version you are working on?
If it is BI 7.X, use of InfoPackage to load data from PSA is not allowed.
As Shilpa said above, you need to use DTP to load data from PSA to targets.
Thank you guys,
i am using 7.X. and if i am not wrong only Data sources have PSA, in my case i am loading data from DSO to cube. so i have created DTP which loads data from DSO to cube, and i could select Delta or Full in DTP option.
But in my case, if i have Delta DTP, then do i have to do init. in order to do delta loads from DSO to cube ?
or just delta DTP will take care of delta loads ?
Hi Sandy,
You need not create any init when you are using a DTP. When you run a delta DTP for the first time, all the requests from the source will be retrieved and data will be initialied.
Regards,
Shilpa
Hi Sandy,
You can do the delta init using DTP like this.
Load the data for the initial selections which you want from the source using a full dtp and then you can initialize the delta as shown below
Regards, Joe
