on 05-22-2012 10:12 PM
Hi Gurus,
I have the following message when I try to load data from a DSO to infocube :
Cannot load request to real-time data target
Message no. RSSTATMAN043
Diagnosis
You are trying to load data into a real-time InfoCube using a DTP.
This is only possible if the correct load settings have been defined for the InfoCube.
Procedure
In the object tree of the Data Warehousing Workbench, call Load Behavior of Real-Time InfoCube from the context menu of the InfoCube. Switch load behavior to Transactional InfoCube can be loaded; planning not allowed.
I have checked my infocube is not a real-time infocube. Could u pls help me in resolving this......
Best Regards
Cedric M
Its clear that you are trying to load the data into a real time cube using DTP. Go to RSA1 -> Your cube -> rt click -> and change the behaviour from Planning mode to Data load mode. After that, you can load the data using DTP.
Rgds..
Shambhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Check table RSDCUBE
-> Fill in the technical name of your Infocube and OBJVERS = A at selection screen.
If in the result, the fields TRANSACT = X
this is an "real time enabled standard cube" -> so you have to switch the behavior for loading/planning.
Regards
Tom
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I faced the same problem when uploading data to my Standard InfoCube.
It turned out that I created my Standard InfoCube by copying from the system-generated APO Planning Area InfoCube (since copying was easier than to create it manually).
However, when copying in this way, system creates an APO Standard InfoCube rather than a BW InfoCube.
If somebody ends up doing the same mistake as me, just delete the InfoCube and re-create it manually, and voila, your DTP will run just fine
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Cedric,
Behavior of the cube should be changed before loading. Being real time cube, if it is planning mode, it should be changed to load mode and then start loading. Once loading is done, change behavior back to planning mode so that users can access.
If the load is through Process chain, change design accordingly to change behavior before and after loading.
Check this thread, which is a similar one
http://scn.sap.com/thread/3170623
Regards
Chandu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
do u have that plan cube ?
in case of loading the data in the cube you have to change the cube status to loading may be and when u need to save the plan data you have to change the type to planning..
all this is available in procdess types..
Thanks and regards
Kiran
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.