Error in Phase MAIN_POST/UEXP_SPDD

[former_member227283]

Dear Friends,

I am doing upgrade from R/3 4.7 to ECC 6.0 with EHP6, Currently i am stuck in Post processing phase (MAIN_POST/UEXP_SPDD).

The error i am getting as :

Last error code set: No message class 'TQ' id 518<br/> error in pre-export activity for TSTK9000012

TST9000012 is my request number of SPDD.

I check in SE91 for message class TQ,  in that i am not able to find class 518.

Kindly suggest.

Thanks,

Anil Bhandary

[Former Member]

Dear Anil,

As per my understanding there are two probable causes for this error.

First one has already mentioned by Paul and if that is not the case then please check the file umodauto.lst and find if there is transport request is mentioned or task ?

If task is mentioned at umodauto.lst not the SPAU request. Then follow the below steps:

Change the umodauto.lst and replace the task with the right request (TSTK9000012)

Save the umodauto.lst.

Hope it works for you.

Regards,

Sachin

[Former Member]

Hi Sachin & Anil

you both are correct, i had same issue with EHP6 upgrade. transport request has been created in other than 000 client and in umodauto.lst has sub task.

i had impleted both then my issue has been resolved.

[Former Member]

Dear Anil,

As per my understanding there are two probable causes for this error.

First one has already mentioned by Paul and if that is not the case then please check the file umodauto.lst and find if there is transport request is mentioned or task ?

If task is mentioned at umodauto.lst not the SPAU request. Then follow the below steps:

Change the umodauto.lst and replace the task with the right request (TSTK9000012)

Save the umodauto.lst.

Hope it works for you.

Regards,

Sachin

[paul_power]

Hi Anil,

Which client was TSTK9000012 created in?

If it was created in a client otgher than 000 it may be the cause of the issue.

-login to the system in client 000
-display the request in transaction SE09
-enter change mode
-a popup is prompted asking the request to be copied to client 000
=> asnwer with YES
-save the request

repeat the phase it should continue now.

hope this helps, if not, please post the log contents and details on client the transport was created in.

Best regards,

Paul

[former_member189725]

It seems the Transport request number is not valid TSTK9000012.

It should be TSTK900012  (1 zero less)

During the "Select for Transport" in SPDD , you might have selected the wrong transport number.

Regards

Ratnajit