08-19-2012 7:49 AM
Hello
We have completed the Upgrade from 4.7 to ERP 6.0 ehp5 non-unicode. Did the preprartory steps for Unicode conversion for SPUMG in the upgrade steps. Now When i verify it in the SPUMG screen (Pre-Conversion), it shows that:
Language Import - Language has been imported which does not match the system config.
Message no. UMGLOG403
Even though SMLT and RSCPINST are consistent and okay.
When I go to SPUMG Menu Screen --> Scanner --> Settings. Please initialize the language lists first! Message no. PUMG076.
Please advise us where need to the language lists first!.
Thanks & regards
AK
08-20-2012 7:44 AM
Hi AK,
are you doing a CU&UC approach according to SAP note 928729 ? This would be the supported process. In that case, you need to run UMG_FINISH_ PREPARATION after the upgrade. Did you do this ?
Best regards,
Nils
08-20-2012 7:44 AM
Hi AK,
are you doing a CU&UC approach according to SAP note 928729 ? This would be the supported process. In that case, you need to run UMG_FINISH_ PREPARATION after the upgrade. Did you do this ?
Best regards,
Nils
08-20-2012 3:03 PM
Hi Nils,
I followed the approach according to SAP note 928729 and run UMG_FINISH_ PREPARATION after the upgrade. There was an inconsistent behavior in the Language Import, even though Language from SMLT and RSPINST are consistent.
Now the issue has been resolved by following approach:
1. Delete the content from table UM4STATUS.
2. Then reset SPUMG (SPUMG -> Scanner -> Restart SPUMG)
3. Then restart SPUMG transaction.
Thanks & regards
AK
01-16-2014 3:55 AM
I also managed to solve this by going to SPUMG > Edit > Language (or simply press F5) Make sure that all your languages are activated (with "X"). If not, edit the row and activate the language. If you select replace the code page to 1160 then change the code page to 1160. Make sure that the language you selected tallies with the language entries you supplied in RSCPINST report and in table T002C.