03-19-2007 4:05 PM
Hi friends
I have created a table control and it is working fine. But I want to edit it and change the order of columns. I am in the layout screen (SE52) and I am not able to drag it and change the order. I double clicked on the columns and I can see the column numbers but they are greyed out.
Is there a way to change the order of the columns?
Your answer will be highly appreciated.
Thanks
Ram
03-19-2007 4:27 PM
03-19-2007 4:25 PM
Hi Ram,
Delete the columns and add them in the order you want again in the screen painter.
Regards,
Ravi
03-19-2007 4:27 PM
03-19-2007 5:29 PM
Ram,
I have found that you can only drag-and-down one screen at a time... meaning IF your table control takes up more than one screen width in the screen painter, you must drag-n-down in "chunks."
Ex: If the column to be moved is last (at the far right of the Tbl Control)...drag it to beginning (or first visble column on the left) in the tbl control.. and drop it there. Then drag (repeatedly as needed) to the left until you reach your desired position.
03-19-2007 10:10 PM
Thanks John
I tried this, but when I drag and drop nothing happens. I tried dragging it to the next field but it just stays in the same column.
I would appreciate anymore suggestions that I can try.
Thanks
Ram
03-20-2007 4:39 AM
Hi Ram,
Make sure that you are in change mode.
Select the cell you want to move from the first row ( not the heading ) and drop where you need it. It will work surely.
regards,
S. Chandra Mouli.
03-21-2007 1:26 PM
Thanks Chandra
I think that was the mistake that I was doing. I was trying to drag with using the header and your suggestion solved myproblem
Thanks to every one who responded to my question. I appreciate it a lot.
Ram