SM59 ERROR for register XMIIIDOC02

[Former Member]

Hi Guru,

I registered the XMIIIDOC02 program to send IDOC from ECC to MII according to the document of Michael Appleby

However, i still face issue when test the RFC connection, Anyone please help me on this?

Logon: Connection Error

Error Details: Error when opening an RFC connection

Error Details: ERROR: program XMIIIDOC02 not registered

Best Regards!

Lawrance

[agentry_src]

Hi Lawrance,

What version of MII and NW are you using?

Previously you had mentioned registering the Program ID, but NW/MII automatically registers the Program ID for you if you follow the steps outlined.  If you manually register the Program ID, you will have two destinations defined and likely will see some or all of your IDocs not arriving at the correct destination.

This will seem like a simple problem, but how many "I"s are there in XMIIIDOC02 for each location you entered it.  I have seen this error from that simple typo in the past.

Regards, Mike

SAP Customer Experience Group - CEG

[Former Member]

Hello Mike,

The version of MII is 14.0.2 Build(82)

The version of NW is EHP7 for SAP ERP 6.0

And also I follow the steps you mentioned in your PDF documents

However i still get the error message as below:

Logon	Connection Error
Error Details	Error when opening an RFC connection (CPIC-CALL: 'ThSAPOCMINIT' : cmRc=2 thRc=67
Error Details	ERROR: program XMIIIDOC03 not registered
Error Details	LOCATION: SAP-Gateway on host ecca20.pacific-textiles.com / sapgw00
Error Details	DETAIL: TP XMIIIDOC03 not registered
Error Details	COMPONENT: SAP-Gateway
Error Details	COUNTER: 2166
Error Details	MODULE: /bas/740_REL/src/krn/si/gw/gwr3cpic.c
Error Details	LINE: 1950
Error Details	RETURN CODE: 679
Error Details	SUBRC: 0
Error Details	RELEASE: 740
Error Details	TIME: Fri Mar 28 09:39:44 2014
Error Details	VERSION: 2

[agentry_src]

Hi Lawrance,

Is your NW version 7.3 or something else?

Did you check the spelling of the Program ID in all the places you reference it?  Make sure there are three "I"s consistently.

You should also take a look at this Discussion.  In particular the SAP Note that Former Member mentioned.

Regards, Mike

SAP Customer Experience Group - CEG

[Former Member]

Hi Michael,

Yes, we are on the NW version 7.3.

I can also confirmed that the 3 I are there in the program ID,

By accident, My connection for XMIIIDOC02 is connected,

However, i don't know why, the XMIIIDOC03 and others are still not ok

Really annoying,

Really hope to get your reply.

Best Regards!

Li Dong