MIC result recording not transfer to Batch management

[Former Member]

Dear QM expert

I am trying to linking MIC to class characteristic in IDES. Follow this blog . In MIC creation (QS21) my class charateristic assign

After result recording in MSC3N I get

Please suggest me.

Regards

Shamim

[former_member221025 · Accepted solution]

Hello Shamim,

1. Results will be transferred after saving Usage Decision.

2. MIC status in your 1st screenshot is " Being Created", It must be Released.

3. You need to flag Batch Valuation without material specification indicator in Plant dependent QM settings> Insp. lot Completion if you are using inspection plan.

Amol.

[Former Member · Accepted solution]

Dear Mr. Amol

Point 1 & 2 are I have done. Please tell me details about your point no.3. If possible plz give screenshot.

Thanks in advanced.

Regards

Shamim

[nitin_jinagal · Accepted solution]

Hi,

Follow this path,

Go to QCC0> Basic settings>  QM plant dependent settings> Inslot completion.

There, set the indicator for 'batch valuation without mat specs'

ntn

[nitin_jinagal]

Yes Correct.

If you follow the documents, you can find this difference from the Fifth screen of the doc (under 2.2).

Also you need to look after the Point no. 4 written at the end of the Document. You need to close the inspection lot to update the inspection results into the batch.

I have also added this point in the document. Thanks for bringing this into in.

ntn