on 04-09-2014 4:20 PM
Hi, all,
I have just installed the starter kit.
The controls don' t occur in the consoldation monitor.
What are the conditions that controls are displayed in the consolidation monitor?
Can anybody give me some advice?
Thanks in advance and best regards
Gerd
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Gerd,
The first thing to check is whether the controls are enabled for this model.
You can do this in the Adminastration of BPC
Note: in order to enable it, you need to have valid work-status setup
Then, you also need (obviously) some valid controls and sets
Here is a good link that explains controls in BPC 10
Hope this helps!
Marc
HI Gerd,
Could you please indicate what do you mean by consolidation Monitor?
Which version of BFC are you using?
A screenshot woul be appreciated.
Best regards,
Siwar Taleb
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.