on 04-24-2014 3:29 PM
Hi guys,
I experience some challenge getting my addon to install successfully on a 64-bit SBO 9.0
I noticed there are a couple of discussions touching on this very subject.
So I have successfully installed my addon on the 32-bit edition of SBO 9.0
My addon is built using VS2010 C# and the addon installer(setup) is built using InstallAware.
I use the very same setup script for my 64-bit compatible addon (btw, i can manually launch and run this addon successfully in 64-Bit SBO 9.0)
When I run the addon setup, it runs through to the end but i get an SBO system message 'Add-on XXX : Installation failed'
During the setup debug, I saw the commandline coming from SBO points to the 32-bit AddOnInstallAPI.dll instead of the 64-bit AddOnInstallAPI_x64.dll
Could this be the cause of the 'installation failed' message?
If so, how can I get the commandline pointing to the 64-bit AddOnInstallAPI_x64.dll?
Thanks in advance.
Regards,
Esau
Hello,
In the end, i used the 32-bit dll in a 64-bit installer and it worked ok.
Another point to remember is to call the EndInstallEx function (in my case, i was calling EndInstall)
Your installer should work ok after this.
Kind regards,
Esau
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.