JMS receiver will it be taking the soap envolpe with pay load?

[former_member270261]

Hi Experts,

i am using the JMS receiver communication channel.

Under processing tab--------->PI setting under------->Mapping message-ENTER MASSAGE= JMS PAYLOAD if i select this option

will it be going with payload soap envolope?

for your reference sending screen shot to you?

Thanks

Narendra

[Harish · Accepted solution]

Hi Narendran,

Please refer the below help page

https://help.sap.com/saphelp_nw73/helpdata/en/10/b1b4c8575a6e47954ad63438d303e4/frameset.htm

1. Select the Mapping of Message:
   • If you only want the JMS payload to contain only the payload of the PI message, choose Message Payload = JMS Payload. (default setting)
   • If you want the JMS payload to contain the entire PI message, choose Entire Message = JMS Payload.

So if you select Entire message then it comes with JMS header else only the payload.

regards,

Harish

[former_member270261 · Accepted solution]

Hi Harish,

thank  for your for quick response.

if i am using this  option(Entire Message = JMS Payload)this will directly take soap envolpe with payload or do i need enable to any option?

Thanks

Narendra

thanks

Narendra

[Harish · Accepted solution]

Hi Narendran,

If your source system is sending message with soap envelop then it should picked up with payload. AFAIK - entire message contains the JMS header information.

regards,

Harish