cancel
Showing results for 
Search instead for 
Did you mean: 

Payroll results Not Displaying

Former Member
0 Kudos

Dear All,

I have configured all the necessary steps to run the payroll.

No errors reported so far.

While checking the results everything is showing -0.

Please guide me how to proceed further.

Sumana

Accepted Solutions (0)

Answers (2)

Answers (2)

jrg_wulf
Active Contributor
0 Kudos

Hi Sumana,

you said, that you had configured all steps - but did you actually run them?

  1. Ascertain that export statement is active  in your main scheme
  2. Set the payroll area (TA PA03 or menue)
  3. Run the payroll (Report RPCALCx0) - make sure, that the correct scheme is chosen and that simulation is unchecked.
  4. inspect the payroll protocol for the number of calculated results
  5. set payroll area to correction (PA03 or menue)
  6. Run correction payroll if necessary
  7. close periode for payroll area (PA03 or menue)
  8. check results.

Best regards - Jörg

Former Member
0 Kudos

Dear Jorg,

I have gone to all the steps as you mentioned, but still there is no change.

Regards,

Sumana

Former Member
0 Kudos

Hi Suman,

Are you using Std schema or custom schema ?

configured the remuneration statement for Payslip ?

can you specify step wise how you are running the payroll for the employee ?

sikindar_a
Active Contributor
0 Kudos

Old schema or standard Schema the results should get updated in RT cluster right based on that it will get displays in CEDT remuneration statement m there can be only one change that is PRCL 20 which pushs the wage type to RT.

Former Member
0 Kudos

Hi,

I have used the following schemas

1.  copied standard schema U000 to YCOO

2. Copied UTX0  to YCTX and done changes.

Regards,


Sumana

sikindar_a
Active Contributor
0 Kudos

Can you execute live payroll run and check Payresult once

PC00_M10_CALC remove Test run and execute and corss check the RT results

Former Member
0 Kudos

Dear Sikindar Sir,

I have done as per the instructions.

Once again checked & I copied new schemas.

Still same error.

Please find the below screens hots.

sikindar_a
Active Contributor
0 Kudos

Just Cross check the below

Employee hire date and for period which you are running payroll and his payroll area

Former Member
0 Kudos

Dear Sikindar,

Thanks for your inputs. based on your suggestions it is working.

Now the problem is I want to run the payroll from  01/07/2014 on wards.

But in the system log it is showing 10/2013  (01.01.2014-31-12-2014)  Regular payroll run is 02/2014.

How to rectify this.

regards,

Sumana

Former Member
0 Kudos

Dear All,

Thanks for your inputs.

This thread is closed.

Regards,

Sumana

sikindar_a
Active Contributor
0 Kudos

Check whether results are updated in RT via Tcode PC_PAYRESULT

Former Member
0 Kudos

Hi Sikindar,

I run the PC_PAY RESULT.

Please find Screen Shot.

Regards,


Sumana

sikindar_a
Active Contributor
0 Kudos

Results are not updated please run live payroll and cross check