on 09-08-2014 7:55 AM
Hi Experts ,
I have one requirement where Material need to be created directly in active area with out any approval process.
So I need to bypass staging area data store.
Please give your valuable input to achieve that.
Thanks in advance.
Regards,
Samrat
Hello,
From the discussion above, I can understand this is a requirement. However, I would like to understand the reasoning behind this requirement. The whole point behind MDG is to avoid direct creation of master data and instead "govern" the process first. If you are going to create material, then use MM01 directly as Sanjay suggested.
If you are looking for a web-based UI, you are better off looking for a standard Web Dynpro application (or create your own) instead of mis-using the MDG application.
In any case, you can't completely by-pass the staging area. However, you can configure a single-step rule-based workflow such that the material goes into "activation" immediately. Keep in mind that the material will not be available immediately, but will take a few minutes depending on your system configuration until the material is activated completely in the system. Error handling, etc. will need to be done on the MDG layer which could prove to be an unnecessary burden should you decide to go this route.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please see my response above:
"In any case, you can't completely by-pass the staging area. However, you can configure a single-step rule-based workflow such that the material goes into "activation" immediately. Keep in mind that the material will not be available immediately, but will take a few minutes depending on your system configuration until the material is activated completely in the system. Error handling, etc. will need to be done on the MDG layer which could prove to be an unnecessary burden should you decide to go this route."
Hi Abdullah,
Are you referring that these configurations can be controlled by BRF+ table entries?
I tried modifying the single value decision table for entry 00 and made the new change request step column to 99(Also tried 91), but still I couldn't see the material getting created directly at the active area. It is still expecting me to choose the Activate button(similar to the role of approver) from my workflow inbox.
Could you elaborate how to achieve this?
Thanks
Bala
Hi Samrat,
You can modify the Single value user decision table for material by updating the "New Change request Step" column value to 91(instead of 90) for conditional alias 1.
Thanks
Bala
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Samrat
You can create it direcly in ECC using MM01.MDG meand Mastern Data Governance (Governance is noting but approval processes)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
11 | |
11 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.