CU50 configuration result

[Former Member]

Hi

In the super BOM I have put a class (type 200) as a component item 10 without dependency specified. A raw material is assigned to this class. When I check the configuration result of the finished product, this raw material is not picked. Instead, it's showing the class name for item 10. But in planned order simulation of CU50 and actual sales order planning, the raw material is picked without any issue. Is that normal?

milk

[Rachel_Tang · Accepted solution]

Try to implement the following SAP notes:

2016159

1960898

They should solve the problem.

[Ritz]

milk bike,

Its not normal, usually you should get same result in configuration simulation CU50 as well as actual plan order.

you can compare you setup with

Thanks

Ritesh

[Former Member]

Thank you Ritesh. I have made verification a few times with that blog but it seems all the steps were ok... can't figure out what's missing in it

[Ritz]

can you share screen shot  showing comparison ?