on 10-23-2014 6:43 PM
Hi guys,
I have created an Load from datastream to an infoprovider on other system . Did the mapping but when executing the task I am getting UCF7033 No data has been read from the source data stream.
But checked the mapping Source selection and did a test listcube with the source selection from the task log . When I do so I receive any data from the system where the source cube is located but when executing load from datastream I am getting this message that no data has been read. Can you let me know where I can put a break point to see where the problem is? Or what would you suggest to do?
Any advice welcome.
Regards,
murat
Hi Murat
Normally these types of issue will trigger when there is mismatch selection in the LDS Mapping tab page.
As mentioned above by Hugo SAP message explained when these issue will trigger which helps you a lot to understand and also check these setting in mapping table.
Cons unit, FS Item, RPT Current...
Regards
Rajesh SVN
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Murat,
Maybe this note can help you:
953173 - No data has been read when executing data stream load
method
Best Regards,
Hugo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.