cancel
Showing results for 
Search instead for 
Did you mean: 

User-Defined Text Key 1 in dangerous goods

rohan_somji
Active Participant
0 Kudos

Hello,

               We have a field in DG master User-Defined Text Key 1 in tab Printed text. Need to understand how does the value get populated in this field like where do we need to maintain the value in specification workbench. Technical help says "The text is output whenever a transport document is issued". But I couldn't understand the same.

We have a requirement where we need to build a logic that if a particular material X has transport Indicator maintained as Limited Quantity in Dangerous Good Release master then when we run DG filling it should update one particular phrase xxxx-xxxxxxxxxxxx.

Thanks in advance.

Regards,

Rohan

Accepted Solutions (0)

Answers (1)

Answers (1)

rohan_somji
Active Participant
0 Kudos

Hi,

          Got the VAT Dangerous Goods User-Defined Texts. But what we have observed is When we maintain it for Reg. for e.g. CFR_RAIL and run DG filling the value gets updated in DGP3. But when we try to do the same with Reg. IMDG and run DG filling the value does not gets updated in DGP3. Does this have anything to do with SPRO node "Specify Profiles for User-Defined Dangerous Goods Texts"

Can anyone kindly throw some light on this one.

Regards

Rohan

christoph_bergemann
Active Contributor
0 Kudos

Dear Rohan

not sure about your explanation. Therefore: in DG you have a lot of "regulations" (e.g. IMDG); now you need to prepare dataa in EHS-BD so that DG filling can work; I believe you need "mapping"; e.g. if you have maintained VAT Dangerous Goods User-Defined Texts with Standard/REG_World teh DG maste rmust get perregulkaiton the same data; but if you have maintained e.g. two data records in the VAT one valid for RID and one for ADR (only an example) you need to differentiate the data instances by usage so that filling is data properly

May be check:

consolut - GGA_200_300_220 - Specify Profiles for User-Defined Dangerous Goods Texts

For LQ:

Gefahrgutabwicklung (EHS-DGP) - SAP Library

rohan_somji
Active Participant
0 Kudos


Hi Christoph,

                         Thank you for your kind reply. After hours of investigation we found out the real cause. It was config. "Specify Checkbox Structure for Dangerous Goods Master". Here field PDGF1 (User-Defined Text Key 1) Regulation CFR_RAIL we had kept the update check box as active whereas for IMDG we hadn't. Hence despite filling the field for IMDG was not getting updated. Once we activated the check box for IMDG data started getting updated in the DG master.

Once again Thank you for your guidance. Appreciate it.

Regards,

Rohan