on 11-06-2014 10:02 PM
Hi,
We are using bw 7.3 we have created IP input ready query and using Bex analyzer analsyis grid we created planning application. after executing query
in the analsysis grid we are not able to enter the new rows. we looked at the note:1149346 and we have made all the required settings and we have all prerequisties in the bex queries but we are not able to enter the new rows in the analsysis grid. can u please share ur ideas on this.
Thanks
Regards
SG
Hi,
Please check the following:
1. Is your cube in plan mode?
2. Is your query built on aggregation level?
3. Is "Start in change mode" set ?
4. Is KF in the query marked as "input ready" ?
5. Are all of the characteristics that not in the row restricted with single values?
6. Are there some locks in RSPLSE?
BR,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
show us a picture of your query. It could have several reasons. lots are listed by Andrey, but it coul also be that you use key figures in rows, or you use inverse formulas or something else ...
regards
Cornelia
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.