0FI_AA_12 re init

[Former Member]

Hello,

I have changed BWFIAASIM parameter to 1 in BWOM_SETTINGS table as it was not set before.. Also there are some changes happened on data model level.

Now I need to delete and reload complete data for data source 0FI_AA_12.  I just wanted to ask, while re initializing data source 0FI_AA_12, do I need to do re init for other data source like-- 

0ASSET_ATTR_TEXT 

0ASSET_AFAB_ATTR 

0FI_AA_11 

0FI_AA_12

DO I need to follow above re init sequence again or I can only re init and load for data source 0FI_AA_12??

Please suggest.

Thanks,

VIshal

[RamanKorrapati · Accepted solution]

Hi Vishal.

Other data sources are not required to do the reinit again.

Try to do init for your data source.

later you can run above sequence loads and finally load your data source loads.

Do the loads at dev system and later follow the same at prod system.

Thanks

[Former Member · Accepted solution]

Hi Rama,

Thanks for your reply.

Our model is already in place. I need to load data for 0FI_AA_12 only. due to changes.

So do i need to load for all data sources or i can only load for this data source?

Thanks,

Vishal

[RamanKorrapati · Accepted solution]

Hi,

Just load full load to your data source.

later you do init without data transfer for your data source.

After that you can load above data delta loads  and later you can run delta load of your data source.

Just to know clear idea,  please test at dev system.

Thanks