Suppress warnings in analysis for excel

[Former Member]

Hello folks,

Is there a way to suppress/hide warnings in Analysis for excel when data is saved or retrieved?

There are some technical details in the warning which the users don't want to see.

Appreciate your help.

Thanks,

Vasu

[TammyPowlas]

In the Settings > Support Settings tab, have you unclicked the checkbox next to "Show Suppressed Messages"?  By default that is left on.

Tammy

[Former Member]

Thanks @Tammy

I tried that already. It doesn't suppress any messages.

Vasu

[TammyPowlas]

Would you please specify which messages you would like to suppress?

[Former Member]

Tammy,

Following are the main messages. There are some more listing the data and characteristics causing these messages.

Characteristic combination cannot be assigned to a part provider (RSPLS_CR-017)

Cannot generate combinations for MultiProvider 'ZCOOM_M03' (RSPLS_CR-013)

I tried to suppress them in Bex/BW (in RSRT) but do not see an option to suppress these messages.  So, the only other way is to do it at Analysis.

Thanks again,

Vasu

[TammyPowlas]

Vasu - I haven't personally seen these messages but you may want to check the config in your backend BW system

I went to SPRO and found this:

There's a "suppression of messages" - might be something to try in your BW backend system.

[Former Member]

Thanks Tammy.

Tried that option in SPRO but still the messages are showing up.

FYI, the queries am using are Input ready based on a BI-IP model.

I may have to do an exit/enhancement in the Classes to suppress the messages.

P.S. I see an idea in idea place requesting "suppress messages" feature on the Analysis side.

[TammyPowlas]

Hi Vasu - I didn't know about the planning part

I am not familiar with BI-IP

Sounds like it is a good idea to go vote for the idea on Idea Place.

Good luck.

Tammy

[j_vandersterren]

Hi Vasu,

Did you fix the problem?
Do you know why message is RSPLS_CR-013 is shown?

Regards,

Jos.