on 11-25-2014 6:08 PM
Hi Experts,
I am having a File to Proxy scenario. When the file is picked up by PI, it is failing due to message error. When i check for the payload, it is empty in RWB. I am able to view the payload for the other messages.
Can this happen because the payload was not generated properly?
What can be the reason?
Regards,
Lavanya R
Hi Lavanya,
What PI release and SP are you on?
Regards
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Lavanya,
Have you tried to check the audit log in the communication channel monitoring?, any exception there?
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Lavanya,
are you sure that you are able to inbound payload for other message? If you are not able to see the inbound payload for other message then set the below property to see both sender and receiver payload in message monitoring.
MS=3 & AM=3, this will enable to have receiver payload as well.
Please find below link for more detail:
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Are you doing any content conversion in file sender?
>>>Can this happen because the payload was not generated properly?
It could be possible. Did you check the source file? is it valid?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.