CRM order replication issue

[former_member552168]

We have created order in CRM QA system, order has been saved without any error, but it is not replicated to ECC QA.

While we check SMQ1 in CRM msg showing SYSERROR "Screen output without connection to user",

Plz suggest, below screen for your reference, plz.

[former_member196467]

Hi JK

Most likely there seem to be an RFC issue in SM59.

Please make sure the ECC destination is registered in SM59.

Please use also the report CRM_ODE_CHECK_CFG of note 490932 to check the interface settings.

Best regards - Christophe

[former_member552168]

Hi Christophe,

This is especially for the new orders (Plant (New) ) except  this ( PLANT BAWAL this has been created long back but client want to use now) all the orders are replicating n also i checked all  the configurations in CRM, time of find target system it is giving error msg in SMQ1, i am suspecting that some configurations missing in  ECC, not sure.

Plz suggest any source.

Regards,

JK

[former_member196467]

Hi J K

It seems likely that you get a dump in the ECC system, can you check it?

Please consider also notes 1739959 - DYNPRO_SEND_IN_BACKGROUND

and notes 49730, 673402 and 1620893.

Best regards - Christophe

[former_member552168]

Hi Christophe,

Thanks a lot for your support, we have solved the issue, that is TPC (Custom) system issue.

Thanks once again,

Regards,

JK

[former_member196467]

Hi JK

Good to hear that the issue got solved.

Best regards - Christophe

[Former Member]

Dear JK,

Can you please elaborate the issue and the solution you found for that as well.Awaiting your response in this regard.

[Former Member]

Strange. So maybe the system wanted to produce an output on a screen but it was run in background.

Did you get a short-dump in ST22?

If not, then maybe googleing or an OSS-message will help.

Best regards,

Thomas Wagner