cancel
Showing results for 
Search instead for 
Did you mean: 

Request (XXXXXXXX) has not or not correctly been updated; Please edit

Former Member
0 Kudos

Hi Experts,

while Activate DSO i am getting this error:


Request (XXXXXXXX) has not or not  correctly been updated; Please edit 

i got these solution on SDN but in my case by mistake we also Deleted PSA request too so what we ca do not.

Reason for this error message is :

The reason is,request number has been updated to PSA, but not yet to

DSO. Since all delta requests to DSO must be in correct sequence,

the system will check old requests and issue this error.

For more details you can check this note :

.https://service.sap.com/sap/support/notes/595028

595028  Loading/activating ODS: delta requests not yet updated

Solution for this error message is :

There are two ways to solve the same :

  • You need to first update request to DSO, then try to activate DSO data.
  • If you do not need that request, you should delete it from PSA or set it to red.

PS :  Set the OLD update request in the monitor to RED (using a QM action).

          As a result, it is then ignored in the check. This is not only a

          'workaround', it is also logical step, because a new update request

           replaces the old update request when the delta administration is reset

           and the change log is reupdated.

          The old update request then becomes obsolete and should no longer be

           used (in InfoCubes).

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

i also got this solution but again we donot have that request any more in PSA too, what we can do now:

1. Request - set the QM status Red and delete it from the target

2- ReLoad the IP/ DTP Once again. it will take the same delta records as you have set the QM status to red for the request which had been loaded.

3- After the request gets loaded then activate it again.

Former Member
0 Kudos

Hi VIshal,

Are you able to solve the issue...if so please mark it as answered..

Regards

Former Member
0 Kudos

Hello Vishal,

Do a delta run again to capture data in PSA then update in the further targets. You will get the same records from Repeat delta.

Also delete the request that is not getting activated by manually making it red.

Regards,

Amit