Master pulling issue

[Former Member]

Hi Everyone,

when we pull suppose 10 products from R3 to APO after completion of process when i check in APO in MAT1, i found 6 product exit in APO and remaining 4 not exit in APO while all 10 product exit in R3. so what i need to do so that my all master can pull successfully in APO

Thanks and Regards

Narwdeshwar

[pravin_tikar · Accepted solution]

Hi Narwdeshwar,

as you explain 6 product are available in APO and 4 not.

Then compare one product (which in apo) setting (in r/3 mm03) with those products not transferred to APO.

Also check your IM for product.

Follow procedure for testing

1. go to CFM1, Enter Model, select Logical system,APO Application

2. Select Material Checkbox,

3. Enter the 10 materials in Material textbox,

4. then execute

5. You can see the number of material(should be 10) if not 10 then check master data.

If count is 10 then you have to check queue manager in APO

/n/sapapo/cq.if any queue is block check and correct.

Hope this will help.

Regards,

Pravin Tikar

[Former Member · Accepted solution]

Thanks Pravin

[Former Member · Accepted solution]

Please close the thread once you get the solution.

[Former Member · Accepted solution]

Thanks Pravin and Rohit,

My issue has been resolved, and i have pulled my all Mater data in APO, if few SKU has pulled in APO and few not then no required to check integration model, only need to check setting in mm03 for those SKU not transfer to APO

Regards

Narwdeshwar

[Former Member]

Hi,

Can you please check your integration model in product master data CIF job. see if any specific selection is maintained for plant or any plant specific material status is maintained which is restricting those products to CIF across.

Thanks.

[Former Member]

Thanks Rohit for ur reply