cancel
Showing results for 
Search instead for 
Did you mean: 

ATD quantity calculation is incorrect when we check at the disaggregated level

Former Member
0 Kudos

Hi Experts,

When we load a single product location in the planning book, we are able to see the correct value of ATD quantity appearing in the planning book, whereas when we load multiple products and locations and then check the ATD quantity when disaggregated for the same product location, we are seeing different values. Basically, (ATD qty is getting calculated as ATD Receipts - ATD issues).

When checking at the disaggregated level, basically the ATD Receipts is showing the wrong qty which results in the incorrect ATD qty calculation as well.

Could you please share your thoughts as to why we have different value getting calculated when checked at disaggregated level.

BR

Kumar

Accepted Solutions (0)

Answers (3)

Answers (3)

former_member187488
Active Contributor
0 Kudos

Hello,
Have you applied note 1682504?

BR/Ada

Former Member
0 Kudos

Hi Kumar,

Please takes in consideration these few things.

The rounding value can influence the calculation of the ATD quantities. If you use different deployment profiles for your SKUs you can also have different results. Another factor that can influence is if the demand exceeds the supply. The system (based on the deployment profile) will create 100 % ATD for some SKUs and for the other SKUs maybe just 70%.

Please takes in consideration all this things and at the end if you are convinced that the system still calculate wrong quantities you have to open a message to SAP support.

Hope that can help you!

Thanks.

Regards, Marius   

Former Member
0 Kudos

Hi APO experts,

Could anybody provide their suggestions to the reported issue please.

BR

Kumar