12-21-2014 8:14 PM
Hello Friends
Im facing a problem when preview a PO ; IT WILL PREVIEW THE DOCUMENT CORRECTLY BUT IF I RE PREVIEW AGAIN
Some variables get doubled every time i re preview without getting out compleetely from ME23N then it will be ok
Im clearing all my variables in perform processing in my print ptogram..
It will happen also when i do a mass print from the spool
Any one has a clue of what i should do ?
Thanks a lot
12-22-2014 3:31 AM
Hello Tahar,
Check the vriable in the Driver Program whether they are clearing before it is calling second time.
Because the Variable in the smartforms will be cleared in the global_clear form routine by the system.
If you share issue with screen shot then it will be clearer to understand.