Delta for 2lis_03_itm not working

[former_member212698]

Hello Experts ,

I have done initialization without data transfer for 2lis_02_itm.

when I run job in LBWE  for delta .

It went successfully, however  when check in RSA7  and  click on display it goes on running for more than 15 mins So I stoped the transaction .

I checkd LBWQ/SMQ1 , tried to excute LUWs manually there also I got  following message

" LUWs in status NOSEND must be picked up by the application "

Then When I run Info packege , it went to RED with error : Error Occured in Source system .

Kindly suggest .

Regards,

Ganesh

[former_member212698]

Hi Mehmet Ozgur Unal,

RAS7  screen shot below .

Info package Screen shot below .

Then , SMQ1

Yes I tried delta with new Info package still getting same error .

Kindly suggest .

Regards,

Ganesh

[former_member183155]

Hi ;

To analyze your problem we have to check source system.

Please , check this path.

Infopackage screen shoot , you shared. Go to this screen. You will see sections.

Goto --> Source system

Fill username and key after that run program. You will see root of problem.

Regards.

M.Ozgur Unal

[former_member183463]

Hi Ganesh,

check  the program RSDBTIME in SE38 on the both systems,

is there any time gap between the  both systems,

caller 09 message means... its time issue... between the  servers.

Br,

Kamal

[RamanKorrapati]

can you replicate data source and activate it.

Later try to run dleta info pack and see.

Have you checked ECC SM37 logs?

[former_member212698]

HI,

Below is the SM37 logs in ECC when I run delta infopackage .

Kindly suggest .

[former_member220624]

Hi Gaanesh,

Looks like a connection issue.

Please take help from Basis team in your project.

They will be able to help you regarding RFC connections.

Regards,

Amit

[former_member183155]

Hi ;

Could you replicate data source with RSDS ?

Regards.

M.Ozgur Unal

[RamanKorrapati]

check more error info about your issue at ST22.

error showing as RFC issue. Mean during your load ECC and BW connections may not be in place.

Replciate data source once again into bw and activate data source.

Later try to check ECC/BW RFC connections are active/properly exist.

if not then ask basis team help and activate them.

[former_member183155]

Hi Ganesh Jagdhane ;

Firstly , share screen-shoots of LBWE configuration steps. Is it use direct queue , it is not ; you have to schedule delta queue.

However , can you share message number or details of error ?

Regards.

M.Ozgur Unal

[RamanKorrapati]

Hi,

Can you check more error information from ECC SM37.

After the init have you done any changes(respective data) at source side before triggering LBWE job.

Once you see record count(>0) at RSA7 against your data source later you can run delta info pack.

After the init have you created delta info pack or you used previous delta info pack?

Thanks