on 03-03-2015 11:18 AM
Hi,
Facing below issue.
When we enter plant, material & qty and storage location is determined from material master (st.loc.ep), either ADRN2 or ADRNR are not getting populated. And ADRN2 is getting populated, next time when the PO item is changed.
where as, when we enter storage location manually apart from other entries, ADRN2 value is getting populated.
Did any one come across this issue
Referred below sap notes. But could not get answer for above behaviour.
1975508 - Code sample to fill EKPO-ADRN2 when only Plant given in Purchase Orde
I just checked in my system, in both cases value of ADRN2 can be seen after you save the PO number and the ADRN2 will change immediately if you will change the storage location in an existing PO.
The KBA 1975508 also says the same. Read again the section "Cause"
It explains the standard behavior of system.
If your question is different, then please explain little more with example.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Have you checked after save the document ? Just save the document and display the document from ME23N, then check.
If still it is not coming, then check storage location's address in OX09. Is it showing the same address in PO line item ?
Please post screen shot of both storage location's address and PO line item.
Are you sure that the address is copied from storage location's address ?
Can you see the same address in PO line item which was maintained for the storage location ?
Or it could be a program error, check the OSS note with same symptoms 1973192 - Address number missing when creating item with storage location
**Edited by: Dibyendu Patra
User | Count |
---|---|
98 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.