on 03-05-2015 2:19 AM
Hi,
I have configure a job with 3 wait events as the conditio but currently the job is trigger if one of those wait event is raised but i need all the wait event to be raised then only the job should be trigger to run. Any thought on this?
Regards,
Chris
Hello Chris,
Is your setup also possible with 1 event definition? In that sense, that all 3 raisers raise the same event instead of using 3 separate event definitions?
Regards Gerben
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please provide a screenshot of your setup in waitevent tab.
Out of the three, set one event to auto-submit - "always", and for the rest of the two - set autosubmit to "Never"
thanks
Nanda
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Serhat,
Do you mind to explain in more detail set up your method using the job chain ? As i cannot see there is any tab/collumn to define the event in the steps inside the job chain as i only allow to define job definition inside the job chain. Looking forward for your advise.
Regards,
Chris
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.