on 03-25-2015 9:12 PM
Hi, my example is...
- inspection lot sample size is 10
- 4 of the sample units are rejected
- several different defects have been found for those 4
- so how can I specify defect 1 is for rejected sample unit 1, defect 2 is for rejected sample unit 4, etc?
It seems to me all the defects entered in the defect recording for an inspection lot assume to be for each of the rejected sample units... and sometimes this is not the situation. Is there a report type or report category that will provide a field(s) to enter this information?
Thanks in advance for your feedback.
Aida
Hi Aida,
If you want to record the defect and sample unit combination, Please record the each defect in separate line item and maintain the sample unit number is the text field, against the each defect line item.
If it is ok to you, Please confirm
Thanks
Regards,
Bala
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Aida,
Honestly, I might be wrong - but I think at MES execution level, you can track it through some non-SAP LiMS reports at such granularity, and not at SAP level as this is a higher end system.
Thanks,
Arijit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.