Data Source Filter Error - 0CO_PC_PCP_10

[Former Member]

Hi all,

I am facing a problem in the data source 0CO_PC_PCP_10. I have configured a filter of date (KADKY) to select a range of date, but during the extration the filter doesn´t work. The selection fetch all dates instead of fetching only the range selected.

Does anybody knows about this problem?

Thank you,

Gustavo

[KodandaPani_KV · Accepted solution]

Hi,

are you checking at ECC RSA3 or BW side?

give thee proper selection both side you will get desired output.

-Phani.

[Former Member · Accepted solution]

Hi Phani,

I am checking in the BW side.

Thank you,

Gustavo

[Former Member · Accepted solution]

Hi Gustavo,

I am assuming that you have changed the value of SELECTION = 'X' in the table ROOSFIELD for making the field as selection enabled.

I am sorry to break it to you that it will not work because in the extraction FM for this datasource the extraction is done on table KEKO and below selection criteria is hard coded in FM.

So even if you make other fields as selection possible it will never work.

Unless SAP releases a patch/Note to modify the FM SREP_COPC_PCP_10 and make it more field selection enabled.

I think it is better to use KADAT if you want to use selection criteria and then manipulate your data in BW further using KADKY.

Please let me know if there are any questions.

Thanks

Amit

[Former Member · Accepted solution]

Hi Amit,

I have not changed the value of SELECTION = 'X', but I saw that KADKY was not in FM as you told me. For sure it would never work because of it.

I changed the selection to KADAT and it works.

Thank you very much for your help.

Gustavo

[Former Member · Accepted solution]

Thanks Gustavo, glad to know that it works with KADAT.

Can you please close the thread by marking the desired reply as correct?

Regards

Amit

[RamanKorrapati]

Hi,

Where your getting issue?

mean at info pack level or dtp level?

is it delta dtp?

Thanks

[Former Member]

Hi Raman,

I am getting this issue in the infopackage level. The DTP is delta, but not in this level.

Thank you very much.

Gustavo

[RamanKorrapati]

Hi,

info pack is delta one? is your data source is already set delta pointer?

Are you above give selection value pattern was correct?

Can you give one selection value and test the extraction at info pack and see.

Thanks

[Former Member]

Hi,

Our load is full with a selection in the infopackage level and the same problem happens when we test inside RSA3.

Thank you!

Gustavo

[RamanKorrapati]

please look for oss note at SAP market place or Raise ticket to SAP support.