on 04-16-2015 9:44 AM
Dear All,
I have printer configured as mentioned below
Device Type:-SAPWIN : MS Windows driver, latin1.
Device Class:- Standard Printer.
Access method: F:Printing on front end Computer.
Host printer : __Default
I have strange problem, when I print from this printer. Different printers are giving me different print outs.
What I have checked from my side.
Format of the paper is same for every printer.
Drivers are properly installed on local machine.
Any other suggestions?
Regards
Dharmendra
Hi Koli
With smart forms your development team have to work in the output format,
on the other hand could you try with next configuration?
Deviceattributes
Device type: SWIN :MS Windows driver, Latin-1
Device Class: Standard printer
Acces Method
Host Spoll_ G: Front End Printing with control Tech
Host printer: __DEFAULT
best regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I have strange problem, when I print from this printer. Different printers are giving me different print outs.
Could you please elaborate this in detail about different print outs ? Mean while try to use Access method G in place of F by following SAP doc at Front-End Printing with Control Technology (Access Method G) - SAP Printing Guide (BC-CCM-PRN) - SAP...
and SAP Note 821519 - Front-end printing with control technology
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I tried printing 1 invoice from on 3 different printers, there was cut out from bottom from one printer. then on 2nd printer alignment was shifting. 3rd printer was printing it ok.
for 2nd invoice the logo was printed incorrectly (I reverse order) on 1 printer and for other 2 it was ok
for cheque it is printing cheque on A4 size paper but if I give envelope it will not print.
All of the above invoices print preview are OK and if I print it in pdf form its printing it fine.
Regards
Dharmendra
I had to switch to a POST2 device type due to Adobe form creations causing issues with SAPWIN; the PDF device type fixed that, however wouldn't allow for duplex. POST2 has worked flawless, until we deployed into Mexico and discovered that none of the printers were licenced for postscript printing (only PCL).
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.