on 04-20-2015 8:21 PM
Hi Guys,
I am generating the labels in the system by CN-ZH. Chinese to Chinese language.I have installed the Chinese language pack in the WWI server as well as in the Microsoft word. and i have set up the RFC with Unicode settings. but still i am unable to generate the labels in the Chinese language. (i came to know that in the I 18 transaction , we need to activate the Chinese languages is that true/ is it will helpful for me?)
Please help me on this.
Thanks
Vishwanath
Hi Guys,
I had resolved this issues.
I had followed below mentioned 4 steps to resolved the UNICODE for China.
1. Environmental parameter , i had set it as X
2. I had maintained the RFC as UNICODE in SM59.
3. I had maintained the correct data in SAPRFC INI file.
4. Installation of language pack in the MS word.
Now, I am able to develop and generate the labels in the Chinese language.
Thank you'
Vishwanath
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Vishwanath,
as stated by Mark; your message is to "unspecific". Do you get a "generation with warning"; do you see chinese characters in report (or are they missing etc.)
To use eastern language in WWI reports can be a challenge (same for SAP system as well)
Please check OSS marketplace. You will find lot of WWI Oss message regarding use of "Eastern languages" in WWI
On top: ALWAYS USE (IF POSSIBLE) current WWI version to generate the documents
C.B.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vishwanath,
Chech that you are running the Unicode Version off WWI (that is WWI*U.exe) and that the EH&S Environment Parameter WWI_IS_UNICODE is set.
AFAIK you do not Need to activate the language via I18N.
Regards
Mark
P.s.: Information about the error would help.... 😉 - "unable to generate" is a bit too general ...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Good morning,
In lack of further detail, may I recommend the following:
ensure you have installed the language in I18N,
ensure as well that the language is defined as a phrase language in SPRO, EHS / Basic Data and tools / Phrase Mgt / Specify language selection
double check that Chinese phrases are loaded (CG13)
...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
10 | |
5 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.