on 04-21-2015 10:58 AM
Hi all,
I am on a system with level
SAPKW73008
when defining a filter selection in planning modeler using variables, I would like to seelct the "current cal year2 variable with some offset.
Normally there is a box where i can enter the offset but the box is not there - see attached picture.
I there any patch or setting missing?
thanks
Cornelia
Hi,
Check note 1791547
Hope it helps
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
we applied 7.3 SP 12 and the offset box is back again
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.