on 04-28-2015 9:00 AM
Hi All
I am getting the following error while mkaing BOMBOS transfer.
Specify at least 1 unit
Message no. BM018
Diagnosis
No unit was included. Conversion or determination of conversion factors is therefore not possible.
I am not able to figure this out , please if any body can help me out.
Thanks & Regards
Satish
Hi Satish,
I haven't had this error so far, but you could check the base unit of measure of your material master, net weight of the material master and the UOMs that were used in the BOM that you tried to transfer.
There seem to be some inconsistencies...
If it would be just a missing unit conversion the message would be different.
Regards,
Andreas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
12 | |
7 | |
3 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.